The following is a general guide to installing aftermarket clear corner lights onto your car. We only provide these instructions to give you an idea of what you will need to do in order to install the clear corners. We highly recommend that you have your lights installed by a professional experienced in aftermarket installation.

Remove the stock corner blinker piece by placing a piece of cloth in between the small and large corner lights. Put a flathead screw driver in between both of these lights and slowly pry the smaller corner piece away from the body of the car. Normally they are only connected by a little ball and socket device, so it should remove fairly easily. Once you get the light out, remove the bulb by twisting counter clockwise and replace with clear lense and don't reinstall it just yet.

Next for the larger orange turn signal, use a phillips screwdriver to remove the single screw holding it down and the whole piece will pop out. Remove the bulb and replace with the new clear corner piece. Put the larger corner back in, and secure with a screw.

You'll realise, that if you try pushing the remaining piece back into the old ball n socket hook, the lense will have a tendency to pop out. For this reason, you want to lock it in place. Remove the metal "ball" part of the clear lense and remove the plastic "socket" part that is on your car. You want to put the washer on the inside of the car and tighten the screw to the lense from the inside.

From underneath the fender of the car, remove the 2 screws keeping the black fender wall attached to the car frame. Pry open enough space, to get your hand to slide in a socket wrench. Now tighten the "ball" metal screw to the lense with the washer in between it. It should go SCREW->WASHER->CAR->LENSE. Tighten the screws with a few turns and you're set. Close up the fender wall and repeat other side.